We studied cleaning and annealing effects in glass/Si direct bonding using 4 inch Pyrex glass and silicon wafers. SPM cleaning (sulfuric-peroxide mixture, RCA cleaning and combinations of these two methods were examined to investigate the wafer cleaning effect. When wafers were cleaned by RCA after SPM cleaning, maximal bonding quality at room temperature was gained. Surface roughness, as measured by AFM (atomic force microscope), was found to correspond with bonding quality at room temperature. Bonding strength increased as the annealing temperatures increased to but debonding occurred at The difference in thermal expansion coefficients of the glass and the Si wafer used led to this debonding. When wafers bonded at room temperature were annealed at 300 or the bonding strength increased for 28 hours, and then it decreased with further annealing. The decrease in bonding strength caused by further annealing was due to sodium ion drift through the glass/Si interface.
Skip Nav Destination
e-mail: ycjoo@plaza.snu.ac.kr
Article navigation
March 2004
Technical Papers
Effects of Wafer Cleaning and Annealing on Glass/Silicon Wafer Direct Bonding
Hong-Seok Min,
Hong-Seok Min
School of Materials Science & Engineering, Seoul National University, Seoul, Korea, 151-742
Search for other works by this author on:
Young-Chang Joo,
e-mail: ycjoo@plaza.snu.ac.kr
Young-Chang Joo
School of Materials Science & Engineering, Seoul National University, Seoul, Korea, 151-742
Search for other works by this author on:
Oh-Sung Song
Oh-Sung Song
Dept. of Materials Science and Engineering, The University of Seoul, Seoul, Korea, 130-743
Search for other works by this author on:
Hong-Seok Min
School of Materials Science & Engineering, Seoul National University, Seoul, Korea, 151-742
Young-Chang Joo
School of Materials Science & Engineering, Seoul National University, Seoul, Korea, 151-742
e-mail: ycjoo@plaza.snu.ac.kr
Oh-Sung Song
Dept. of Materials Science and Engineering, The University of Seoul, Seoul, Korea, 130-743
Contributed by the Electronic and Photonic Packaging Division for publication in the JOURNAL OF ELECTRONIC PACKAGING. Manuscript received April 2003; final revision, September 2003. Associate Editor: Guo-Quan Lu.
J. Electron. Packag. Mar 2004, 126(1): 120-123 (4 pages)
Published Online: April 30, 2004
Article history
Received:
April 1, 2003
Revised:
September 1, 2003
Online:
April 30, 2004
Citation
Min , H., Joo, Y., and Song, O. (April 30, 2004). "Effects of Wafer Cleaning and Annealing on Glass/Silicon Wafer Direct Bonding ." ASME. J. Electron. Packag. March 2004; 126(1): 120–123. https://doi.org/10.1115/1.1649238
Download citation file:
Get Email Alerts
Enhancing Mechanical Reliability of Silver-Sintered Joints With Copper Nanowires in High-Power Electronic Devices
J. Electron. Packag (December 2024)
Special Issue on InterPACK2023
J. Electron. Packag (December 2024)
Impact of Encapsulated Phase Change Material Additives for Improved Thermal Performance of Silicone Gel Insulation
J. Electron. Packag (December 2024)
Related Articles
Finite Element Modeling of Structural Relaxation During Annealing of a Precision-Molded Glass Lens
J. Manuf. Sci. Eng (August,2006)
Magnetic Field-Assisted Finishing of Silicon Microelectromechanical Systems Micropore X-Ray Optics
J. Manuf. Sci. Eng (October,2012)
Annealing of Compression Molded Aspherical Glass Lenses
J. Manuf. Sci. Eng (February,2014)
Thermal Annealing Effect on the Optical, Electrical and Morphological Properties of the PBTTT-C 12 :PC 71 BM Blend Films
J. Sol. Energy Eng (June,2015)
Related Proceedings Papers
Related Chapters
Insulating Properties of W-Doped Ga2O3 Films Grown on Si Substrate for Low-K Applications
International Conference on Advanced Computer Theory and Engineering, 4th (ICACTE 2011)
Surface Analysis and Tools
Tribology of Mechanical Systems: A Guide to Present and Future Technologies
The Relation between Cold-Work-Induced Microstructural Evolution and the Postannealing Grain Structures in Zircaloy-4
Zirconium in the Nuclear Industry: 20th International Symposium